Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Spring Replacement Cost in Lake City?
Spring repair in Lake City typically runs $180 – $340 for a single torsion or extension spring, and that range covers the spring, the labor, and the tensioning. Most homes here have two springs working as a pair, and since a matched pair gets replaced together, a full two-spring job lands at roughly twice that range. The written estimate we give you after looking at the door is the price that holds, so you’ll know the number before anything comes off the brackets.
Why Springs Fail at All
A torsion spring stores the energy that lifts your door. Every open and close cycles it through thousands of pounds of tension and release. In Lake City’s wet half of the year, a garage that stays cold and damp most of the time works its spring through temperature swings on the same metal coil, and at some point the coil gives. Torsion springs usually break after a set number of cycles, and a busy household door racks those up faster than people expect. When one goes, you hear the crack from inside the house.
What matters isn’t just that the coil snapped. It’s that the door now has no helper, so the opener is dragging a dead weight. Running that opener can strip the gear or burn the motor, which is how a $200 repair turns into a $500 one. If your door won’t lift or you’ve heard a loud snap, stop using the opener until someone has looked at it.
A note on safety
Torsion springs and the cables attached to them are under high tension, and the wrong move with a winding bar can break a wrist or send metal across the garage. This is not a job for a general handyman, and it’s certainly not a job for a homeowner with a hardware-store winding rod. Our technicians treat it as a specialty, which is why we handle it in-house rather than handing it off. If a spring has broken, leave the door closed and call. We’ll take it from there.
Spring Replacement Cost Breakdown (2026)
Here’s how the numbers usually shake out for Lake City homeowners. These are typical estimated ranges, not a quote, and the written estimate sets the final price.
| Job | Typical Estimated Cost |
|---|---|
| One spring replaced (torsion or extension) | $180 – $340 |
| Matched pair of springs (about twice the single-spring range) | $360 – $680 |
| Cable repair | $130 – $250 |
| Roller replacement | $110 – $220 |
| Track realignment | $120 – $240 |
| Panel replacement | $250 – $500 |
| Opener repair | $120 – $320 |
| Opener installation | $250 – $550 |
| Full new door installation | $700 – $2,200 |
| General garage door repair | $150 – $600 |
Springs rarely fail in isolation. When a coil snaps, it often takes a cable or a roller with it, and a door that’s hung on a bad track wears its springs faster. That’s why the estimate usually covers the spring plus whatever the door actually needs to run right. The spring alone is the base number; the rest is what the inspection turns up.
What Affects Spring Replacement Pricing in Lake City
The single-spring range is tight, but several things push the cost toward one end of it or the other. Here’s what changes the number:
- One spring or two. A pair costs roughly double a single spring. Most doors built for two springs should have both replaced even if only one broke, because the second coil is the same age and under the same cycles. Replacing one and leaving the tired one in place usually means a second call sooner than you’d like.
- Spring type and size. Torsion springs on the shaft above the door are the common setup on newer Lake City homes; older doors often use extension springs along the side tracks. Torsion jobs take more care and a bit more time, and custom or high-cycle springs for a heavy door sit at the top of the range.
- Door weight and size. A single-car door with a light steel panel is a smaller job than a double door with insulation and glass. Heavier doors need higher-tension springs, and the size of the spring has to match the weight of the door.
- Condition of the rest of the door. A misaligned track, worn rollers, or a frayed cable adds to the job. Track realignment at $120 – $240 or a cable repair at $130 – $250 gets folded into the estimate so the new spring isn’t fighting a bad door.
- What’s already been done. If someone has been at the springs before with the wrong size, or the door has springs of mismatched tension, we may need to reset the balance from scratch. That’s more time on the shaft, and it’s reflected in the estimate.
- Parts availability. The right spring has to match your door’s weight, not just its size. Because we keep parts on hand, we’re not waiting on a third-party supplier to ship a coil that fits a specific door, which keeps the job moving on the same visit in most cases.
Repair or Replace? The Spring Question
If the only thing wrong is a broken spring, replace the spring. A full new door installation at $700 – $2,200 makes sense when the door itself is failing: rotting panels, a bent track that won’t sit true, or a door that’s been hit and never hung right since. Springs are a wear item, like brake pads. You replace them and keep the door.
There’s a middle path worth knowing. If the springs are fine but the opener is old and straining, an opener replacement or repair often costs less than people assume and takes the load off the door. General garage door repair in Lake City typically runs $150 – $600, so it’s worth getting an honest read on what’s actually failing before you decide.
For a closer look at what a full replacement involves, our spring replacement service walks through the door-side of the work, and if you’re weighing a new door we can help you sort through the options.
How to Save on Spring Replacement
A few practical moves keep the bill at the low end of the range without cutting corners on the repair itself.
- Get the estimate before you approve anything. Free estimates mean you can compare numbers, and the written estimate is what you’ll actually pay. Call (888) 991-5420 and ask for the estimate in writing.
- Replace the pair together. It sounds counterintuitive, but replacing both springs in one visit usually costs less than two separate jobs with two service calls spread over a few months. It also avoids the second surprise.
- Fix the small stuff at the same time. Replacing a worn roller or realigning a track while the tech is already on the ladder is cheaper than a separate visit. Rollers run $110 – $220, and track work $120 – $240, but bundling them cuts the repeated service-call cost.
- Don’t wait on a single broken spring. Running the opener with a broken coil wears the motor. That’s how a spring job becomes an opener job too. The sooner the door is fixed, the less the opener risks.
- Ask what your door needs, not just what broke. A good estimate explains why the spring is sized the way it is and whether the door is balanced. That’s what keeps a repair from needing a redo.
Free estimates are one of the simplest ways to know your number. Call (888) 991-5420 and we’ll give you a straight answer on what your door needs.
Why Choose a Specialist for Spring Work
Springs are dangerous, and that’s the whole reason this belongs with someone who does them regularly. A generalist handyman may be careful, but careful isn’t the same as trained. We treat spring work as a core service, not a side line. Our technicians have up to 11 years of experience, and the crew that shows up knows how to read a door’s balance, choose the right spring for its weight, and wind it safely.
We work with eight major brands: LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor. Door manufacturers and opener brands are often separate systems, and getting springs and an opener to work together takes knowledge of both. Whatever brand is on your door, we know it, and one call covers the whole door: springs, opener, hardware, or a new install. You won’t need a second company to finish what the first one started.
You can see the full range of what we handle on the Lake City Garage Door Repair page, or read more about spring replacement if you want the detail on how the job works.
FAQs – Spring Replacement Cost
How much does spring replacement cost in Lake City?
A single spring typically costs $180 – $340, and a matched pair runs about twice that, roughly $360 – $680, since most doors need both replaced together. The written estimate sets the final price. Call (888) 991-5420 for a free estimate on your door.
Can a broken spring be replaced the same day?
In most cases, yes. A broken spring is one of the jobs we can usually turn around quickly, and we keep parts on hand so we’re not waiting on a supplier. Call (888) 991-5420 and we’ll tell you the earliest we can get to it.
Should I replace one spring or both?
Replace both if your door has a pair. The second spring is the same age and has taken the same cycles, so it’s likely to fail soon after. Replacing the pair in one visit usually costs less than two separate calls. Call (888) 991-5420 to talk through your door.
Is it cheaper to repair or replace my garage door?
Replacing the spring is almost always the cheaper route at $180 – $340 per spring, because a spring is a wear part, not a structural failure. A full new door installation at $700 – $2,200 makes sense when the panels, track, or structure are failing. Call (888) 991-5420 and we’ll give you an honest read on which one your door needs.
Can I replace a garage door spring myself?
No, and we’d strongly advise against it. Torsion springs are under high tension, and a mistake can cause serious injury. A broken spring means a closed door and a call to a trained technician, not a trip to the hardware store. Call (888) 991-5420 and let us handle the tension safely.
Get a Straight Answer on Your Spring
If your door won’t lift, you’ve heard a snap, or you just want to know what a spring replacement will run, we’ll give you a clear estimate for your Lake City home. Our technicians arrive with parts on hand, work on the major brands, and treat spring work as the specialty it is. One call covers the whole door, and the written estimate is the price. Call (888) 991-5420 for a free estimate, and we’ll tell you what your door needs and what it’ll cost before any work starts.
Pricing reflects the Lake City market as of 2026. Lake City Garage Door Repair offers free estimates – call (888) 991-5420.
What Our Customers Say
"Opener works, remotes are programmed, no complaints on the work. Took three days to get on the schedule though, so if you've got a car trapped inside, say so when you call."
- Holly Fletcher"Replaced the bottom panel after I backed into it. Color match is close enough that you have to know to look for it."
- Bethany Kowalski"Door installed in about four hours, old one hauled away, and he stayed to program both cars and the wall panel before he left."
- Allison Walsh